Canon EOS C200 EF Cinema Camera and 24-105mm Lens Kit - Manual (Page 83)

83
Adjusting the Focus
• When the Dual Pixel Focus Guide function is used together with Face AF or tracking, the focus guide may not
focus the main subject’s eyes correctly, depending on the direction in which the face is turned.
Peaking
The camera offers two peaking levels.
1 Press the PEAKING button.
• The peaking icon ( J or K ) appears on the left of the screen and the outlines in the image will be
emphasized, depending on the focus.
• Press the button again to turn off peaking.
• Alternatively, you can use the > [ A " Assistance Functions] > [Peaking: VIDEO Output] or
[Peaking: VF Output]
1
setting to turn peaking on and off.
1 k
only.
2 Open the peaking’s [Peaking] submenu to select the peaking level.
> [ A " Assistance Functions] > [Peaking]
3 Select the desired level and then press the joystick.
Magnification
1 Press the MAGN. button.
• ^ appears at the left of the screen and the center of the screen
1
is magnified approximately 2 times.
• The orange frame displayed on the top right of the screen (magnification frame) shows the approximate part
of the image shown magnified.
2 If necessary, use the joystick to move around the magnification frame and check other parts of the image.
• When using the LCD monitor
2
, you can also drag your finger across the screen to move the frame.
• Press the CANCEL button to return the magnification frame to the center position.
3 Press the MAGN. button again to cancel the magnification.
1
If one of the AF frames or a face detection frame is displayed on the screen, the area around the active frame will be magnified
instead.
2 Supplied accessory for the C200; optional accessory for the C200B.
NOTES NOTES
• About Peaking/Magnification:
- You can use the > [ A " Assistance Functions] > [Peaking 1] and [Peaking 2] settings to set the
color, gain and frequency of the two peaking levels independently of each other.
- You can select whether to display the peaking effect from the VIDEO terminal or on the camera viewfinder
( k only) with the > [ A " Assistance Functions] > [Peaking: VIDEO Output] and [Peaking:
VF Output] settings.
- You can select whether to display the magnified image on the camera viewfinder ( k only) and from the
VIDEO terminal, or from the SDI/HDMI OUT terminal with the > [ A # Assistance Functions] >
[Magn.: VF+VIDEO Output] ( l [Magn.: VIDEO Output]) and [Magn.: SDI/HDMI Output] settings.
- You can also use the > [ A " Assistance Functions] > [B&W during Peaking] or >
[ A # Assistance Functions] > [B&W during Magn.] to switch the screen to black & white while using the
respective assistance function.
- The assistance functions will not affect your recordings.