EastWest Hollywood Orchestra Opus Edition Virtual Instrument Plug-In (Download) - Manual (Page 155)

HOLLYWOOD ORCHESTRA OPUS EDITION C O N T E N T S <
CHAPTER 4: PLAY 155 C H A P T E R <
The THRESHOLD CONTROL determine the Note Velocity or MIDI CC values above which a
note is processed, between values of 0 and 127 (notes below the selected threshold
are not played).
Use the
RATIO CONTROL to determine the resulting Note Velocity or MIDI CC values for
those that passed through the Threshold control.
Use the
MAKEUP CONTROL to increase or decrease the Note Velocity or MIDI CC values
relative to their original values, between values of -127 and 127. Or, enable the
AUTO MAKEUP SWITCH to set this value.
Use the TARGET MODE MENU to select which values the MIDI Compressor should target,
Note Velocities or MIDI CCs.
4.3.7 MIDI Echo
This MIDI Tool creates a delay line with MIDI data, with the ability to change veloc-
ity, tuning and panning over the course of that delay line.
In the DELAY SYNC MENU select a note sub-division: standard sub-divisions (Whole, Half,
1/4, 1/8, 1/16, 1/32, and 1/64), and triplet sub-divisions (1/4 triplet, 1/8 triplet
and 1/16 triplet) are available.
The
DELAY TIME CONTROL relates to the Delay Sync control, essentially changes the sub-
division. For instance, a 1/4 Delay Sync value with a Delay Time of 1 equals a 1/8
Delay Sync value with a Delay Time of 2.
The
REPETITIONS CONTROL determines how many repeats of the delay lines will play. With
3 repetitions selected, you will hear the original note, plus 3 repeats (for a total of
4 beats).
The
VELOCITY DECAY CONTROL will change Note Velocity as a percent of its original value
over the course of the delay line. Use positive values between 100-150% to produce
a crescendo effect, or values between 10-100% to produce decrescendo effect.
The
STOP VELOCITY CONTROL pertains to the Velocity Decay control, stopping the output of
velocities below a certain threshold at higher values.
The
TUNE CONTROL will change fine tuning over the course of the delay line. With posi-
tive values between 0 and 100 cents, the pitch will bend upward, and with negative
values between -100 and 0 cents, the pitch will bend downward.
The
TRANSPOSE CONTROL will incrementally increase or decrease over the course of the
delay line according to the transposition value, that ranges from -12 to +12 semi-
tones. With a value of 1, each delay line repetition will rise by 1 semitone (chro-
matically). Please be aware, if the transposition exceeds the sampled range of the
instrument, nothing will play.