FUJITSU Disk Storage System DX60 - Manual (Page 110)

Appendix A Event Notification Message List
A.2 Message List
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
110
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
I 00000026 9 %d volume(s) deleted This message is
notified when
"Deleted Volume" is
enabled for Informa-
tional Level in the
event notification
setting.
Volume
$a:$b
$a:$b
$a:$b
:
%d volumes are deleted.
%d: Quantity
$a: Volume number
$b: Volume name
I 00000027 9 %d volume name(s) changed This message is
notified when "Vol-
ume Name
Changed" is
enabled for Informa-
tional Level in the
event notification
setting.
No. Name(old) Name(new)
$a $b $c
$a $b $c
$a $b $c
:
%d volume names are changed.
%d: Quantity
$a: Volume number
$b: Volume name (before change)
$c: Volume name (after change)
I 00000030 9 FC port parameters changed (CM#%a port#%b) This message is
notified when "FC
Port Parameters
Changed" is
enabled for Informa-
tional Level in the
event notification
setting.
Connect $a
Transfer Rate $b
Host Affinity $c
Frame Size $d
Reset Scope $e
Reserve Cancel at Chip Reset $f
The FC port parameter is changed.
%a: CM number (0 – 1)
%b: Port number (0 – 1)
$a: Connection topology (Fabric or FC-AL)
$b: Transfer speed
$c: Host affinity (Enable or Disable)
$c: Frame size
$d: Reset Scope (I_T_L or T_L)
$e: Reserve Reservation if Chip Reset (Enable or Disable)
I 00000031 9 SAS port parameters changed (CM#%a port#%b) This message is
notified when "SAS
Port Parameters
Changed" is
enabled for Informa-
tional Level in the
event notification
setting.
Host Affinity $a
Reset Scope $b
Reserve Cancel at Chip Reset $c
The SAS port parameter is changed.
%a: CM number (0 – 1)
%b: Port number (0 – 1)
$a: Host affinity (Enable or Disable)
$b: Reset Scope (I_T_L or T_L)
$c: Reserve Reservation if Chip Reset (Enable or Disable)
Event type
and event
code
SNMP
Trap
Upper: Message
Remarks
Middle: Detail information
Trap
No.
Lower: Description