FUJITSU Disk Storage System DX60 User Manual
Page 33
Chapter 2 Standard Operations
2.1 Powering On and Off
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
33
Copyright 2012 FUJITSU LIMITED
P3AM-5512-03ENZ0
This section explains how to use the Power switch to turn on the ETERNUS DX Disk storage
system. For other procedures, refer to the related manuals.
Procedure
1
Press the power switch ( ) of the controller enclosure.
Controller enclosure POWER LED turns on.
2
After three minutes, check that the READY LED on the controller enclosure are
lit up.
IMPORTANT
•
After turning the power on, it takes about three minutes for the
ETERNUS DX Disk storage system to become READY (i.e. the READY
LED turns on). If an error is detected during the initial power-on
diagnostic phase, a longer time (up to ten minutes) may be required
before the READY LED turns on.
•
Before turning the server on, check that the ETERNUS DX Disk storage
system and the network devices that connect the ETERNUS DX Disk
storage system and the server are all in READY status. If the server is
turned on while any of these devices are not in READY status, the
server may not be able to recognize the ETERNUS DX Disk storage
system.
•
When turning on the power in conjunction with the power synchronized
unit, perform the appropriate waiting process so that the ETERNUS DX
Disk storage system is in the READY status before the server is turned
on. Since it takes up to ten minutes before the ETERNUS DX Disk
storage system change to READY status when an error is detected for a
component during the initial power-on diagnostic phase, take this into
consideration and specify an appropriate waiting process that is
sufficient.
•
When the AUTO POWER switch of the controller enclosure is turned to
"ON", supplying power to the ETERNUS DX Disk storage system will
cause the ETERNUS DX Disk storage system to turn on automatically in
cases such as when the power cord is connected or the power is
recovered after power failure.
When drive enclosures are installed, the power turns on
automatically.
Controller Enclosure
Drive Enclosure
Power switch