FUJITSU Disk Storage System DX60 User Manual
Page 61
Chapter 5 Installing Optional Products
5.1 Installing Disks
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
61
Copyright 2012 FUJITSU LIMITED
P3AM-5512-03ENZ0
4
Install the new disk.
4-1
Press the catch on the disk lock lever to unlock it.
4-2
Insert the disk all the way into in the slot, making sure that it is firmly seated and
keeping the lock lever open.
4-3
Swing the lock lever in the direction of the arrow, until the lock clicks shut.
4-4
Check that the newly installed disk's DISK READY LED lights up green after
approximately 30 seconds.
5
Repeat
for each additional disk.
6
If a wrist strap is used, remove the wrist strap.
7
On the Storage System Status screen of ETERNUS Web GUI, check that the
added disks have been recognized.
IMPORTANT
Hold the disk with both hands to protect against jarring.
Catch
Lock lever
Lock lever