FUJITSU Disk Storage System DX60 - Manual (Page 6)

About this Manual
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
6
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
How Warnings are Presented in this Manual
A message is written beside the symbol indicating the caution level. This message is marked
with a vertical ribbon in the left margin, to distinguish this warning from ordinary descriptions.
An example is shown here.
Additional Information
Symbols Used in This Manual
The following is an expression used throughout this manual:
Abbreviations Used in This Manual
• "ETERNUS DX Disk storage system" refers to the ETERNUS DX60 S2 Disk storage system.
• "Host Bus Adapter (HBA)" refers to the interface module normally used by the server to
connect to the ETERNUS DX Disk storage systems.
"Interface module" may be referred to as "FC card", "LAN card", "Network Interface Card
(NIC)", or "SAS card", depending on the type of server and interface that are used.
• Trademark symbols such as ™ and ® are omitted in this document.
Warning Level Indicator
Warning Type Indicator
Warning Details
To avoid damaging the ETERNUS DX60 S2 Disk storage system,
pay attention to the following points when cleaning
the ETERNUS DX60 S2 Disk storage system:
- Make sure to disconnect the power when cleaning.
- Be careful that no liquid seeps into the ETERNUS DX60 S2
Disk storage system when using cleaners, etc.
- Do not use alcohol or other solvents to clean
the ETERNUS DX60 S2 Disk storage system.
Warning Layout Ribbon
Example Warning
Functions and know how which can be useful when setting up or operating
the ETERNUS DX60 S2 Disk storage system.