FUJITSU Disk Storage System DX60 - Manual (Page 14)

Chapter 1 Components
1.1 Controller Enclosure
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
14
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
●
2.5" type
Figure 1.6 Operation panel (2.5" type controller enclosure)
●
3.5" type
Figure 1.7 Operation panel (3.5" type controller enclosure)
● Part explanation
• Power switch
This switch is used to turn on or off the ETERNUS DX Disk storage system.
• AUTO POWER switch
Enables the AC Auto-Link Mode (This function automatically turns on the linked device once
AC power is supplied).
The Auto Power function is disabled for the factory default setting.
• MODE SELECT switch
Enables the device power to be turned on via power linkage.
The MODE SELECT switch is enabled for the factory default setting. Do not change to OFF.
With a flange cover Without a flange cover
AUTO POWER switch
IP RESET switch
MODE SELECT switch
Power switch
CACHE LED
POWER LED
READY LED
FAULT LED
IDENTIFY LED
With a front cover Without a front cover
AUTO POWER switch
IP RESET switch
MODE SELECT switch
POWER LED
FAULT LED
CACHE LED
Power switch
READY LED
IDENTIFY LED