FUJITSU Disk Storage System DX60 - Manual (Page 37)

Chapter 2 Standard Operations
2.3 Attaching and Removing the Front Cover
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
37
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
2.3 Attaching and Removing the Front Cover
This section explains how to attach and remove the front cover of the 3.5" type controller
enclosure or 3.5" type drive enclosure.
■ Procedure for attaching the front cover
Attach the front cover in the following order.
Procedure
1
Fit the front cover in the left end slot of the controller enclosure to attach.
CAUTION
Do
• After completing the operation, be sure to reattach the front cover.
This section explains how to attach and remove the front cover of the 3.5"
type controller enclosure, but the same procedure is used to attach and
remove the front cover of the 3.5" type drive enclosure.
IMPORTANT
Be careful so that the part of the front cover to be fit in the slot does
not touch the power switch (
).
Slot