FUJITSU Disk Storage System DX60 User Manual
Page 68
Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
68
Copyright 2012 FUJITSU LIMITED
P3AM-5512-03ENZ0
■ For regions other than EMEA&I
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the
rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance
between the front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the
rack rail must be attached to the rack before they can be completely tightened.
(2)
Attach the rack rails to the rack.
•
If the rack pillars have square (approx. 9mm) holes, screw
holders will need to be used when attaching the rack rails.
•
Make sure to attach the rack rails and rack pillars so that they
fit exactly together without any space between them.
(Front rack pillars)
(Rear rack pillars)
Rack rail (for right side)
"R" is stamped on the inner
side of the rack rail
(for right side).
Loosen the M4 screws, and
adjust the rack rails to the depth
of the rack.
[Left]
[Right]
Rack rail (for left side)
"L" is stamped on the inner
side of the rack rail
(for left side).
(Front rack pillars)
(Rear rack pillars)
Rack rail (for right side)
Rack rail (for left side)
Washers
M5 screws
Washers
Washers
Washers
M5 screws
M5 screws
M5 screws