FUJITSU Disk Storage System DX60 - Manual (Page 35)

Chapter 2 Standard Operations
2.2 Attaching and Removing the Flange Cover
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
35
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
Procedure
1
Press and hold the console panel's power switch ( ) for 4 seconds or longer.
The READY LED should turn off.
2
The ETERNUS DX Disk storage system power is turned off.
When the power is turned off, the POWER LED will go out.
End of procedure
2.2 Attaching and Removing the Flange Cover
This section explains how to attach and remove the flange cover of the 2.5" type controller
enclosure.
IMPORTANT
Press the Power switch only once. If the Power switch is pressed
again while either the POWER LED or the READY LED is on, the
ETERNUS DX Disk storage system power may turn on.
When drive enclosures are installed, the power turns off
automatically.
Controller Enclosure
Drive Enclosure
Power switch
CAUTION
Do
• At the completion of this operation, check that the flange cover is
attached.