FUJITSU Disk Storage System DX60 - Manual (Page 15)

Chapter 1 Components
1.1 Controller Enclosure
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
15
Copyright 2012 FUJITSU LIMITED P3AM-5512-03ENZ0
• IP RESET switch
Click once to switch the Master CM LAN port from the current controller to the other controller.
Click twice in succession within a two second interval to revert the LAN port settings of the
ETERNUS DX Disk storage system to their factory settings.
• LEDs
The states of LEDs are listed below.
Table 1.1 Status and meanings of each LED (operation panel (controller enclosure))
■ Disk
●
For 2.5" Disk
Figure 1.8 2.5" type disk
Figure 1.9 shows the slot number of each disk.
Figure 1.9 Disk slot numbers (2.5" type controller enclosure)
LED name LED status ETERNUS DX Disk storage system status
POWER
(green)
DC power is supplied to the controller enclosure.
READY
(green)
The ETERNUS DX Disk storage system is available for
use.
FAULT
(orange)
The ETERNUS DX Disk storage system is in error
status.
(blinks orange)
A part of the ETERNUS DX Disk storage system
requires preventive maintenance.
IDENTIFY
(blinks blue)
As ordered via ETERNUS Web GUI, the installation
location of the controller enclosure is identified.
CACHE
(green)
There is data in the ETERNUS DX Disk storage system
cache memory.
(blinks green)
Data in the cache memory is saved to a non-volatile
memory.
DISK FAULT LED DISK READY LED
Slot#8 Slot#9 Slot#10 Slot#1
1
Slot#12 Slot#13 Slot#14 Slot#15 Slot#0 Slot#1 Slot#2 Slot#3 Slot#4 Slot#5 Slot#6 Slot#7 Slot#16 Slot#17 Slot#18 Slot#19 Slot#20 Slot#21 Slot#22 Slot#23