Fisher & Paykel E442B - Manual (Page 13)

11
4. Installation
Your Fisher & Paykel Active Smart™ refrigerator
is fitted with front and rear rollers, designed for
moving the product in the forwards and
backwards direction.
Avoid moving the product in a sideways direction as
this may damage the rollers or the floor
covering/surface.
A
Your refrigerator will arrive with the front feet
wound up making moving the product into its final
location a simple task.
B
Roll the refrigerator into its final position making
sure there is the correct air gap between the
product and surrounding cabinetry. See minimum
clearance in cabinetry dimensions table (refer to page 10).
(RF540A only)
C
Adjust the front feet down until the refrigerator is leaning
backward with the front approximately 10 mm higher than
the back. This will ensure a good door closing action. (Refer
to Fig.9).
D
Aligning your refrigerator with cabinetry.
Align the sides of the refrigerator with the cabinetry by
adjusting the hinge side front foot.
Adjust the handle side foot until it touches the floor and
takes a small amount of weight.
Once the refrigerator is in place and aligned with
cupboards/alcove push gently on the front top and check if
the product is rocking or stable.
5. Levelling of refrigerator door
(RF540A only)
For uneven surfaces, front feet can be used to align the
2 doors.
If left hand door is too low, then unscrew the left hand foot
to lift up the cabinet until the two doors top edges
are aligned.
If right hand door is higher, then adjust the right hand foot
in the same way.
Fig.11 Even door alignment
Fig.10 Uneven door alignment
Raise the front of
the refrigerator
Lower the front
of the refrigerator
Fig.9 Refrigerator feet
Installation instructions
EN