Fisher & Paykel E442B - Manual (Page 8)

6
Installation instructions
11 Attach double sided foam to the back of the water filter head as shown
in Diagram 5. Write the date to be replaced on the filter (date installed +
6 months). Remove double sided foam backing and attach filter to the
desired position as located in step 10 (refer to previous page).
12 Run the 6 mm (¼”) tubing to back of the fridge ensuring there is enough
tubing to pull out the refrigerator for service.
13 Connect tubing into the water (solenoid) valve located on the right hand
side of the unit (compressor) compartment as shown in Diagram 7. Beware
of hot pipes.
14 Pull gently on tubing to ensure it is locked in as shown in Diagram 8.
15 The completed installation should look like Diagram 9 on page 7.
Diagram 7
Diagram 6
Diagram 8
16 Turn isolating tap on and check that all connections are dry and free of drips.
17 Coil water line tubing behind the fridge. Push your refrigerator into place being careful not to
kink or squash the water line running into the water (solenoid) valve.
18 The first time you require water out of the dispenser, there will be a delay while the water
reservoir fills up.
19 Run a further 8-10 litres (8-10 qt) through the system to ensure the reservoir is flushed out.
20 You are now ready to enjoy chilled water and ice dispensing from your Active Smart™ refrigerator.
Diagram 5
Fig.6 Double sided
foam attachment
Fig.7 Waterline connection
to refrigerator