FARGO electronic HDP820 - Manual (Page 117)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 103
Resolving the Card Lamination Placement errors
Symptom: The PolyGuard Overlaminate is not centered horizontally on the card
Step Procedure
1 Adjust the Lamination TOF
a. Select MENU, Setup Printer and Lamination TOF.
b. Trailing Edge Adjustment: Adjust the current value to a more positive
number to move the Lamination closer to the trailing edge.
c. Leading Edge Adjustment: Adjust the current value to a more negative
number to move the Lamination closer to the leading edge of the card.
d. Press OK to save the new value.
2 Calibrate the Lamination Sensor.
a. Reset the Printer to clear any Error Messages by removing Power and
reapplying it.
b. Open the Printer control panel from the Computer.
• If using Windows 98Se/ME, right click on the HDP800 Series Card
Printer Icon and select Properties.
• If using Windows NT 4.0, right click on the HDP800 Series Card Printer
and select Document Defaults.
• If using Windows 2000/XP, right click on the HDP800 Series Card
Printer and select Printing Preferences.
c. Click the Lamination tab.
d. Click on the Sensors button.
e. Remove the Laminate ribbon and close the top cover.
Click on the Send button for a Lamination Sensor Calibration.