FARGO electronic HDP820 - Manual (Page 200)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 186
Setting Up the Printer Driver
Once the appropriate Printer Driver for the computer has been installed, you will need to set
the Driver up with the proper print options. To open the Printer Driver setup window, please
refer to the following steps for the specific operating system:
Setting up Windows 98SE/Windows Millennium
Step Procedure
1 Click the Start button, point to Settings and select Printers.
2 Click on the HDP800 Series-LC Card Printer icon with the right mouse button
and select Properties.
Setting up Windows NT/Windows 2000/Windows XP
Step Procedure
1 Click the Start button, point to Settings and select Printers.
2 Click on the HDP800 Series-LC Card Printer icon with the right mouse button
and select Document Defaults... if using Window NT or Printing Preferences...
if using Windows 2000/XP. (Note: If you would like to permanently save the
Printer Driver settings so you will not need to change them again, do so through
the main Printer Driver setup window described above. Although most
applications do allow you to change these same Printer Driver options from their
own Print screens, the settings may not be permanently saved.)
3 To change or verify the appropriate Printer Driver options for the print job, please
refer to the topics describing each of the Printer Driver's tabs.