FARGO electronic HDP820 - Manual (Page 363)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 528
Lamination TAB, 104, 107
Lamination Take-Up Encoder Sensor
Assembly, 327
Lamination, not adhering, 106, 107
Laminator Controls, 37
Laminator Temperature Adjustment, 47
Laminator Warming, 46
LAN (Local Area Network), 511
Landscape, 512
LCD, 78, 82, 113, 122
LCD (Liquid Crystal Display), 512
LCD and Softkey Control Pad, 25
LCD Display, 20, 25, 28, 71, 82, 224
LCD Display Messages, 50, 51, 52, 53, 54
LCD error, 76
LCD Firmware, 474
LCD Interface Cable, 349, 355
LCD Menu, 444
LCD Menu and Selecting an Option, 445
LCD On-Line Menu Navigation, 444
LCD panel, 71, 78, 82
LCD Setting, 83
LCD Setup, 122
LED (Light Emitting Diode), 512
LED Light, 20, 28
less heat, 202
less saturated resin images, 202
Lever Unlocked, 51
LoCo (Low Coercivity), 512
Low Coercivity, 221
Lower Film Drive, 120
Lower Film Sensor, 91, 92
Lower Film Sensor Assembly, 328
lower transfer temperature, 180
LPT Port (Line Printer Port), 512
M
Mag Encode Failed, 54
Mag encoding, 512
Mag stripe, 512
Mag Track, 512
Mag Verify, 512
magnetic card analyzer, 462
Magnetic Encoder, 76
Magnetic Encoder Head, 363
Magnetic encoding area of Printer, 78
Magnetic Encoding tab, 218
magnetic stripe, 79
Magnetic Stripe Encoding Modules, 219
Magnetic Stripe encoding process, 218
Magnetic Stripe verification, 224
Magnetic Test, 78, 82
Magnetic TOF, 462, 463
Magnetic TOF setting, 462
Magnetic Track data, 227
Magnetic Track Options, 222
Magnetic Track Selection, 221
Magnetic Track Selection option, 221
Main Firmware, 471, 473
Main Firmware/LCD Firmware, 471
Main Print Board, 89, 90, 367, 438
Manual Eject Each Error option, 224
manual eject mode, 224
matte-finished cards, 180
Maximum Accepted Card Length Range,
14
Maximum Accepted Card Width Range,
14
maximum value, 206
MB (Megabyte), 513
Measuring area positioned on card, 215
Media, 512
Memory, 513
Memory, 14
Menu, 513
MENU button, 444
Menu option, 26
MENU, Print Test Image and Gray/Align
YMC, 450, 452, 457
MENU, Setup Printer and Encoder
Settings, 461
mistakenly-verified card, 224
Module and LCD Display interaction, 45
Module and Printer interaction, 44
Module’s Programmed Default
Temperature, 46
Monochrome, 192, 513
more heat, 202
Motor operation, 85
Motor Operation, 72
Multi-Language Extension (MLE), 223
Multimeter, 85, 88, 97