FARGO electronic HDP820 - Manual (Page 40)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 26
Printer Components: LCD and Softkey Control Pad (continued)
Component Description
Ready/Printer
Open Screens Once the Printer has finished its system check and with the Print and
Transfer Stations closed, the Printer will display READY to indicate that
the Printer is ready for operation. (Note: The Printer will stay in this
mode until it receives a print job or it is turned OFF.)
• If the Release Lever is unlocked, the Release Lever Unlocked screen
will appear to remind you this item is open.
• If the Print and Transfer Stations are opened, the Printer Open
screen will appear. Press either the Forward or Back buttons to
move the Printer's card path rollers in the indicated direction. Use the
scroll buttons to select between moving the Print-Side Card Rollers or
the Input-Side Card Rollers. This is helpful when cleaning the Printer
or if clearing jammed media. In any of these screens, the Printer will
always display the Menu option above the center softkey button.
Press this button to access the Printer's menu options. (Note: The
Menu option is available only in the Ready/Printer Open screens.)
• If the Printer is equipped with the Card Lamination Module and the
Lamination Station is opened, no LCD message will appear. Instead,
the Lamination Module's LED will flash. (Note: To move the
Lamination Module's rollers, push the Module's Cancel or Resume
buttons.)
• If both the Print Station and Lamination Station are open, the LCD's
FORWARD and BACK softkey buttons will move ALL rollers. In any
of these screens, the Printer will always display the MENU option
above the center softkey button. Press this button to access the
Printer's menu options. (Note: The MENU option is available only in
the READY/PRINTER OPEN screens.)
Continued on the next page