FARGO electronic HDP820 - Manual (Page 238)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 224
Reviewing the Verification options
Use this option, which instructs the Printer to verify that all magnetic data has been correctly
encoded on each card. (Note: With either of these options, the number of verification retries
may be specified. A range of 1-5 retries is available.)
Step Procedure
1 Select the Auto Eject 1st Error option, which instructs the Printer to
automatically eject a card containing magnetic data (that cannot be verified).
• Only the first mistakenly verified card will be automatically ejected. If a
second consecutive card cannot be verified, the Printer will signal an error
and go into manual eject mode.
• The auto eject option is the most direct means of dealing with mistakenly-
verified cards, but may be undesirable (if batch printing) since mistakenly-
verified blank cards are ejected into the same stack as verified printed cards.
OR
Select the Manual Eject Each Error option so the Printer will signal an error on
its LCD Display stating that the magnetic data could not be verified. (Note:
When this occurs, press the Cancel soft key to manually eject the mistakenly
verified card. This option is helpful since Magnetic Stripe verification can
sometimes require more than a single pass.))