FARGO electronic HDP820 - Manual (Page 256)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 242
Adjusting the Transfer Dwell Time and Transfer Temperature
Step Procedure
1 Adjust the Transfer Dwell Time and the Transfer Temperature to control the
Lamination Dwell Time or through-put speed of a card in seconds/inch and the
Lamination Temperature.
Selecting the Sensors button and Defaults button
Step Procedure
1 Select the Sensors button to bring up a separate dialog box to calibrate the
Lamination Sensor. See the next page.
2 Click on the Default button to return the Transfer Dwell Time and Transfer
Temperature to the Default settings for the Lamination Type being used.