FARGO electronic HDP820 - Manual (Page 302)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 467
Using the Show Card Count option
Step Procedure
1 Use this option to view the total Card Count (CC), Pass Count (PC), Transfer
Count (TC) and Lamination Count (LC).
• The Card Count is the total number of cards the Printer has produced.
• The Pass Count is the total number of print passes made by the Printhead.
(Note: A pass is measured each time a single ribbon Panel is printed or
passes beneath the Printhead.)
• The Transfer Count is the total number of times the Printer transfers an
image to a card. In most cases, this information is only necessary for certain
warranty requirements, however, it can also be a helpful way to measure a
Printer's overall work cycle.)
• The Lamination Count is the total number laminated cards that the Printer
has produced.
System Upgrade (Firmware Upgrade)
This option is used to upgrade the Printer Firmware.
Step Procedure
1 Upgrade by selecting SYSTEM UPGRADE.
The LCD will prompt: Are you sure you want to continue?
2 Select YES to begin the System Upgrade, select NO to return to the READY
screen. (Note: See Appendix A: Firmware Update for detailed instructions for
upgrading the system Firmware on the next page.)