FARGO electronic HDP820 - Manual (Page 255)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 241
Selecting the Lamination Type
Step Procedure
1 Select one of the Lamination Type options, according to which type of
Lamination media is currently installed. Two types of overlaminates are
supported by the Driver: Film Lamination and PolyGuard Lamination.
Custom versions of each type are also available.
• Select the Film Lamination option if the Thermal Transfer Film
Overlaminate type is installed in the Lamination Module.
• Select the 0.6 PolyGuard Lamination option or 1.0 PolyGuard
Lamination option for either patch thickness. (Note: These require
different heat settings and Lamination speeds. Select the appropriate
option according to the thickness of the PolyGuard material you are
using.)
• Select the PolyGuard Alternating Patch option only if using PolyGuard
material that has alternating patch configurations on the same roll (e.g.,
full patch on the front of the card and half patch on the back).
Continued on the next page