FARGO electronic HDP820 - Manual (Page 283)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 448
Reviewing the Printer Setup (continued)
Step Procedure
3 Be sure to run this test after each adjustment.
Run the Alignment Test Image by selecting the following options: MENU, PRINT
TEST IMAGE and GRAY/ALIGN YMC. All HDP images must have an extra 0.04
in. (1mm) over bleed on all sides of the card. The Outer Alignment Arrows
should fall in this area when the image is properly centered; they will be left off of
the card when transferred.
See the Reviewing the Color Bars YMC Self-Test in Section 2, page 133. See
the display below.
4 a. Choose MENU, Setup Printer and the setting to be changed.
b. Change the value and press SELECT to save the value.
c. If the settings are lost due to replacing the Main Print Board, set the starting
values to the settings listed on the label on the back of the Printer.