FARGO electronic HDP820 - Manual (Page 257)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 243
Selecting the Sensors button and Defaults button
Step Procedure
1 Select the Lamination Tab's Sensors button to display options for calibrating
the Card Lamination Module’s Lamination Sensor. The Lamination Sensor is
what detects the start of each PolyGuard patch throughout the roll. This
Sensor may occasionally need to be recalibrated.
• If the Lamination Module seems to skip PolyGuard patches or wind the
PolyGuard roll until the Lamination Module's LED flashes, recalibrate the
Lamination Sensor according to the instructions given the in the Calibration
window.
• Be sure the Printer is powered ON and that the Lamination Module's Top
Cover and Lamination Station are closed when calibrating. (Note: This
Sensor is not used if applying Thermal Transfer Film overlaminate.)