Printing on alternate card stocks – FARGO electronic HDP820 User Manual
Page 192
RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
178
Printing on Alternate Card stocks
Selecting the Right Cards and optimize the HDP Print Process
In order to optimize the HDP Card Printer’s capabilities for cards with hard-to-print surfaces,
we recommend evaluating the card stock selection before installation of the Printer.
The variability in cards based on:
•
Different surface textures and different sources of raw materials: This may require
different HDP Film transfer parameters.
•
Varied methods of assembling IC smart cards and proximity cards: These particular
adhesives used to glue a smart chip to a plastic card may react differently to a
Lamination roller’s pressure and temperature.
•
Cleanliness of card stock: The HDP process does not eliminate the need to use clean
card stock. The best-looking card always starts with the cleanest card surface. Dirt and
debris on a card can show up as blemishes on the card surface and may reduce the life
of the image itself.