FARGO electronic HDP820 - Manual (Page 164)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 150
Adjusting the Internal Card Guide (continued)
Step Procedure
2 Adjust the Internal Card Guide according to the card size on which you intend
to print and laminate (CR-80, CR-90 or CR-100). Use the card size markings
on the Internal Card Guide as a general reference for the proper position.
As shown here, position the card size line at the center of the two adjustment
screws. Be sure the Internal Card Guide always remains parallel with the Card
Guide Rail when adjusting.
If necessary, adjust the Internal Card Guide as described in the remainder of
this section.
Continued on the next page