FARGO electronic HDP820 - Manual (Page 42)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 28
Printer Components: LCD and Softkey Control Pad (continued)
Component Description
The Cancel
button Use this button to cancel print jobs and reset the Printer for the next print
job.
• This Cancel function will cancel all print jobs in the Printer and will
completely reset the Printer. In this case, be sure to cancel the print
jobs from the PC before pressing YES.
• Canceling all print jobs (in the middle of a batch print) will force the
Printer to waste or delete any images that may already have printed
on the HDP film.
Caution: To avoid this, select the Print in Single Card Mode
option from the Printer Driver before sending the next print job. If a card
is left within the Printer after a print job is canceled, it will automatically
be ejected.
The Pause
button Use this button to pause the Printer at any time during operation. Note
the Printer will always finish its current task before pausing.
When the Printer is paused, the LED Light will flash and the Pause
softkey button will change to Resume.
Press Resume to continue Printer operation.
The LED Light This light works in conjunction with the Printer's LCD Display to help
communicate the Printer's current status. It is especially effective when
you are too far away from the Printer to read the LCD Display. The
following explains how to interpret both LED Lights on the exterior of the
Printer.
• Off: Indicates the Printer power is OFF.
• Solid GREEN: Indicates the Printer is powered ON and ready for
operation.
• Flashing GREEN: Indicates a Printer ERROR or ATTENTION
condition. Refer to the Printer's LCD Display for information.
Continued on the next page