Sparc64 vii processors added to an existing domain – FUJITSU SPARC ENTERPRISE M5000 User Manual
Page 221
Chapter 12
CPU Module Replacement 12-11
12.2.2
SPARC64 VII Processors Added to an Existing
Domain
Adding SPARC64 VII Processors to an existing domain is a two step process. First
you must prepare the system (see
“Preparing to Add SPARC64 VII Processors to an
) and then you must install the Processors using the
instructions that correspond to your installation scenario.
■
“Adding a SPARC64 VII CPU Module to a Domain Configured With SPARC64
VI” on page 13
.
■
“Upgrading a SPARC64 VI CPU Module to SPARC64 VII on an Existing Domain”
on page 15
▼ Preparing to Add SPARC64 VII Processors to an
Existing Domain
1. If necessary, upgrade to a version of Solaris OS that supports SPARC64 VII
processors.
Note –
The SPARC64 VII processors are supported by the XCP firmware (beginning
with XCP 1070) and Solaris software. For more information about these minimum
software and firmware requirements, see the latest version of the Product Notes (no
earlier than the XCP 1070 edition) for your server.
2. Log in to the XSCF using an account with platadm privileges.
3. Confirm that no FRU is currently listed in Faulted or Deconfigured status.
4. Turn off the power for all the domains.
5. Confirm that the power is off for the domains.
6. Change the key position on the operator panel from Locked to Service.
XSCF> showstatus
XSCF> poweroff -a
XSCF> showlogs power