FUJITSU SPARC ENTERPRISE M5000 - Manual (Page 299)

Appendix E UPS Controller E-5
FIGURE E-2 Corresponding terminals in UPC connector and the UPS cable
Note – If you need UPC cables, you need to make arrangements separately. For
details, contact your sales representatives.
E.6 UPC Connector
This chapter describes the location of the UPC connector and the UPS connections.
■ UPC#0 connects with UPS#0. UPC#1 connects with UPS#1.
■ The single power feed uses UPC#0 only.
■ The dual power feed option uses UPC#0 and UPC#1.
Note: Do not use ER signal.
(Note)
*BTL
*BPS/*UALM
*ACOFF
SG
ER
This system side Cable side
*BTL
*BPS/*UALM
*ACOFF
SG
1
2
3
4
5
6
7
8
9
Pin # Signal name
---
---
---
---