FUJITSU SPARC ENTERPRISE M4000 - Manual (Page 373)

showntp(8)
System Administration 351
NAME showntp - display the NTP information which currently set for XSCF
SYNOPSIS showntp {-l | -a | address | -s}
showntp -h
DESCRIPTION The showntp(8) command displays the NTP information which currently set for
XSCF.
The showntp(8) command can display the following information:
■ NTP servers which have been registered to the XSCF network
■ Status of synchronization with the NTP servers
■ Stratum value which has been set to XSCF
Privileges You must have one of the following privileges to run this command:
useradm , platadm, platop, auditadm, auditop, domainadm, domainmgr,
domainop , fieldeng
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
The setntp(8) command sets the NTP servers used in the XSCF network.
-a Displays all the NTP servers currently set for the XSCF network.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-l Displays whether synchronization with an NTP server is being
maintained.
-s Displays the stratum value which has been set to XSCF.
address Specifies the IP address of an NTP server to be displayed. A
specified IP address is a set of four integer values delimited by
the period (.). If the -a option is specified, the operand is
ignored. The following address form is accepted:
xxx.xxx.xxx.xxx
where:
xxx
An integer from 0–255. Zero suppression can
be used to specify the integer.