Host adapter setup, Initio, Hard disk drive preparation – Initio INI-9090U User Manual
Page 17: Low-level format, Running the smartscsi setup utility, Main menu options, Scan bus
13
initio
®
Hard Disk Drive Preparation
A new SCSI disk drive is normally low-level formatted at the factory to simplify installa-
tion. The drive can be used as it comes from the factory once it is partitioned for
system operation.
Low-level Format
A low-level format will erase any data that is stored on the target disk. Before attempt-
ing to perform a low-level format be sure the data on the target disk has been backed
up. A low-level format can be achieved via the SmartSCSI Setup Utility for
INI-9090U
.
The low level format sets the media to a state which is easily recognized by the host
adapter on the SCSI bus. Once this format is completed, you will need to partition the
drive. Refer to your operating system documentation for further information on
partitioning drives.
Running the SmartSCSI Setup Utility
To start the SmartSCSI Setup Utility, verify that all devices attached to the SCSI bus are
powered up when the host computer system is turned on. Once the power switch has
been turned on and the system begins its on screen power up sequence, the Initio ban-
ner will be displayed for a brief period. During this time the Initio SmartSCSI Setup Utility
is accessible by pressing the <Ctrl> key and the <I> key at the same time. When dis-
played on your system monitor, the following message indicates that the host system is
ready to accept your keyboard input.
!!! Press <Ctrl> <I> for SmartSCSI Setup Utility !!!
Main Menu Options
SmartSCSIs main menu provides five possible setup options for meeting your system
configuration:
s
u
B
n
a
c
S
p
u
t
e
S
e
c
i
v
e
D
p
u
t
e
S
r
e
t
p
a
d
A
p
u
t
e
S
S
O
I
B
y
t
i
l
i
t
U
k
s
i
D
Scan Bus
This option scans the SCSI bus. All device IDs are displayed on the screen including
Host Adapter Setup
4