Novell netware driver installation, Initio, Overview – Initio INI-9090U User Manual
Page 39: Installation
will support Novell NetWare 386 V4.XX or V3.1X with the addition of a software
driver. The installation procedure described here requires some experience in Novell system
setup and administration. The device driver is transferred from the
DRIVER DISK 1
to the hard drive where it is automatically initialized during the system boot
routine. The device drivers listed can support NetWare versions described after the Initio file
Initio Novell adapter driver for V3.1X
ASPI transport layer driver for V3.1X
Initio Novell adapter driver for V4.X or later
Device driver installation file
ASPI transport layer driver for V4.X or later
HAM device driver
HAM device driver installation file
The drivers developed by Initio for NetWare will be installed on the disk drive used for
NetWare system initialization. It is strongly recommended that the selected procedure
be read and understood before continuing with the system configuration or change. Please
read the instructions carefully.
New IntraNetWare Installation
Drivers for the Initio host adapter may be found on the
. In most cases you will load the drivers during a new installation of NetWare
from CD-ROM. The driver is loaded during the NetWare Server Installation procedure.
The NetWare installation program will prompt you for the required parameters as the
installation procedure progresses. It is highly recommended that you have a copy of the
Novell NetWare Installation and Upgrade Manual for reference.
1 At the MS-DOS prompt for CD-ROM installation, change directories to where the
installation files are located.
e.g., d:\ <ENTER>
2 Type INSTALL <ENTER> to initialize the installation routine
3 Select installation Language. <ENTER>.
4 Select NetWare Server Installation <ENTER>
5 Select product type <ENTER>
Novell NetWare Driver Installation