Initio INI-9090U - Manual (Page 33)

29
initio
®
Updating the Initio Windows 95B (OSR2) Device Driver
1 Once a Windows 95 session is established, select MY COMPUTER from your desktop.
Execute the following steps:
• Select CONTROL PANEL from within the MY COMPUTER group
• Select SYSTEM from within the CONTROL PANEL group
• Select the DEVICE MANAGER tab from within the SYSTEM group
• Select the SCSI CONTROLLERS category from within the DEVICE MANAGER
listing
• Select the Initio INI-9XXXU/UW PCI SCSI Host Adapter sub-categories from
within the SCSI CONTROLLERS listing (or any other INI-9100U/UW class of drivers
if you are using an older Initio product)
2 In the INI-9XXXU/9XXXUW SCSI HOST ADAPTER PROPERTIES window, select the
DRIVER tab, then select “UPDATE DRIVER...”
• Select “Next”
• Select the “OTHER LOCATION”
• Type A:\WIN95, then select “OK”
• Select “FINISH”
• At prompt“Insert Disk labled INI-9XXXU/9XXXUW driver ,” select “OK”
• At prompt “Copying file”, replace the highlighted directory path with A:\Win95,
then select “OK.” This will complete loading the INI910U.MPD driver onto your
hard disk drive.
This completes updating the Host Adapter Driver. Follow the on-screen directions to restart
you computer and activate the new driver.
It is highly recommended that you verify Initio’s Windows 95 device driver by selecting MY
COMPUTER from the desktop. Then select CONTROL PANEL:
• Select SYSTEM from within the CONTROL PANEL group,
• Select DEVICE MANAGER from within the SYSTEM group,
• Select SCSI CONTROLLER from within the DEVICE MANAGER listing, and
• Select the Initio INI-9XXXU/UW PCI SCSI Host Adapter entries from within
the SCSI CONTROLLER listing. If “This device is working properly” is displayed
on your screen, the driver has been correctly installed.
Microsoft Windows 95/95b (OSR2) Driver Installation