Initio INI-9090U - Manual (Page 30)

26
initio
®
Updating the Initio Windows 95/95a Device Driver
1 Once a Windows 95 session is established, use your installed mouse or the appropriate
key strokes to select MY COMPUTER from the Main Desktop. Execute the following
steps:
• Select CONTROL PANEL from within the MY COMPUTER group.
• Select SYSTEM from within the CONTROL PANEL group.
2 • Select the DEVICE MANAGER tab from within the SYSTEM group.
• Select the SCSI CONTROLLERS category from within the DEVICE MANAGER
listing.
• Select one of the Initio INI-9XXXU/UW PCI SCSI Host Adapter sub-categories
from within the SCSI CONTROLLERS listing (or select any other INI-9100U/UW
class of drivers if you are using an older Initio board).
• In the INI-9XXX SCSI HOST ADAPTER PROPERTIES window, select the DRIVER
tab, then select “CHANGE DRIVER...”.
• In the SELECT DEVICE window, select “HAVE DISK...”.
3 In the INSTALL FROM DISK window, enter the Initio Driver path name:
• Insert the INI-9XXXU/9XXXUW DRIVER DISK 1 into drive A:
• Type: A:\WIN95, select “OK”
4 Select Initio INI-9XXXU/UW PCI SCSI Host Adapter, select “OK” to install the
INI910U.MPD driver onto your hard disk drive.
It may be necessary to direct Windows to look for the driver in A:\win95 before the driver can be
copied. This step may need to be repeated more than once.
This completes updating the Host Adapter Driver. Follow the on-screen directions to
restart you computer and activate the new driver.
It is highly recommended that you verify Initio’s Windows 95 device driver by selecting
MY COMPUTER from the desktop. Then select CONTROL PANEL:
• Select SYSTEM from within the CONTROL PANEL group,
• Select DEVICE MANAGER from within the SYSTEM group,
• Select SCSI CONTROLLER from within the DEVICE MANAGER listing, and
• Select the Initio INI-9XXXU/UW PCI SCSI Host Adapter from within the SCSI
CONTROLLER listing. If “This device is working properly” is displayed on your
screen, the driver has been correctly installed.
Microsoft Windows 95/95b (OSR2) Driver Installation