Microsoft windows nt driver installation, Initio – Initio INI-9090U User Manual

Page 36

Advertising
background image

32

initio

®

2 If you are installing Windows NT from a CD version, locate the Windows NT Setup

Disk for CD-ROM Installation. Make a backup copy of this diskette before installa-

tion.

3 Insert the backup Windows NT Setup disk into drive A: and turn on your computer.
4 Follow the instructions on the screen until you come to a window titled:

”

WINDOWS NT WORKSTATION SETUP”

(for servers, it will read “

WINDOWS NT SERVER

SETUP

”).

• Press “ENTER” to continue setting up Windows NT.

• Select “S” to skip mass storage detection.

• Select “S” to configure additional SCSI adapters.

5 When prompted by the Windows NT installation, scroll down the list and select

“OTHER (Requires disk provided by a hardware manufacturer)” from the

list of Additional SCSI Adapters. A message will appear on screen stating to:

• Remove diskette in drive A and set it aside.

• Insert

INI-9XXXU/9XXXUW DRIVER DISK 1

and press <ENTER>.

• Select: Initio INI-9XXX SCSI Host Adapter and press <ENTER>.

6 The Initio host adapter driver is now installed The on-screen instructions will

continue for a complete installation of Windows NT. Refer to your Windows NT

users manual for completion of the operating system installation procedure.

Adding or updating the Initio driver to an existing Windows

NT system:

For computer systems using other SCSI host adapters or an IDE drive to provide the

system boot routine, these instructions will guide you through the INI-9XXX host

adapter driver installation. The Windows NT driver will be found on the

INI-9XXXU/

9XXXUW DRIVER DISK 1

. It is important that the SCSI bus hardware and Windows NT are

installed and configured before proceeding further.
1 Once a Windows NT session is established, use your installed mouse or the appropriate

key strokes to select MY COMPUTER from the Main Desktop. Execute the following

steps:

• Select CONTROL PANEL from within the MY COMPUTER group.

• Select SCSI ADAPTERS from within the CONTROL PANEL group.

2 Select the DRIVERS tab from within the SCSI ADAPTERS group.

• In the DRIVERS window, select “ADD…”

3 In the INSTALL DRIVER window, select “HAVE DISK...”.

Microsoft Windows NT Driver Installation

Advertising