Sco unix driver installation, Initio – Initio INI-9090U User Manual

Page 48

Advertising
background image

44

initio

®

Installing the Initio driver in a new SCO UNIX system

1 Insert the SCO UNIX N1 boot disk into the floppy drive and turn on the system. At the SCO

UNIX boot prompt, type: link < ENTER >.

2 The system will ask you what packages you want linked to the system; type: i91u < ENTER

>. The system at this point will boot into SCO UNIX. Please refer to the SCO UNIX Docu-

mentation for additional information. When prompted by the installation, insert the

INI-

9XXXU/9XXXUW DRIVER DISK 2

diskette into your floppy drive; Press < ENTER >

3 Please refer to the SCO UNIX Documentation for additional information. You have com-

pleted the installation of the SCO UNIX driver.

Adding the Initio driver to an existing SCO UNIX system

1 Insert the

INI-9XXXU/9XXXUW DRIVER DISK 2

diskette into your floppy drive.

2 Type: “installpkg” under the command prompt, <ENTER>

3 The system will ask you what packages you wish to install.

Type: i91u < ENTER >

4 Change the directory and rebuild the UNIX kernel:

• cd /etc/conf/cf.d < ENTER >

• . /link_unix

< ENTER >

5 You have completed the link procedure for the Initio device driver. Exit and reboot

the system.

SCO Unix Driver Installation

Advertising