Initio INI-9090U - Manual (Page 44)

40
initio
®
3 Using an appropriate text editor modify the CONFIG.SYS on the OS/2 Diskette 1 for INI-
9XXX to include the new Initio driver.
Enter: BASEDEV=INI910U.ADD and save the file.
* * * note place lines after ‘set os2_shell=cdint.exe’ * * *
BASEDEV=AM201X8.ADD
set copyfromfloppy=1
4 Insert the Installation Diskette into drive A: and turn on your computer. This will
begin the OS/2 installation and establish an OS/2 bootable hard drive.
5 When prompted, insert the “OS/2 Diskette 1 for INI-9XXX.” Follow the on-screen
instructions to continue.
6 You have completed the Initio device driver installation for OS/2. Follow the on-
screen instructions and OS/2 manual for a complete description of OS/2 installation.
Adding the Initio driver to an existing OS/2 system
For computer systems using other SCSI host adapters or an IDE device to provide the
system boot routines, these instructions will guide you through INI-9XXX host adapter
driver installation. The OS/2 driver will be found on the INI-9XXXU/9XXXUW DVR DISK 1 .
It is important that the SCSI bus hardware and OS/2 are installed correctly before pro-
ceeding further.
1 Once an OS/2 session is established, insert the INI-9XXXU/9XXXUW DRIVER DISK 1
into your floppy drive.
2 By using your installed mouse, or by using the appropriate key strokes, select
DEVICE DRIVER INSTALL from the SYSTEM SETUP group.
3 Select CHANGE source directory to read as the root directory.
4 Select OS2 and select SET.
5 Select DESTINATION DIRECTORY.
6 Select CHANGE destination directory to any existing OS/2 directory or accept the
default.
7 Select SET.
IBM OS/2 Driver Installation