Initio INI-9090U - Manual (Page 29)

25
initio
®
Adding the Initio Driver to an Existing Windows 95/95a
System
These instructions will guide you through the installation of the Initio host adapter to an
existing Windows 95 system. Windows 95 will automatically detect the presence of new
hardware in Plug and Play compliant systems. It is important that the Initio hardware has
been properly installed before proceeding further.
1 Microsoft Windows 95 will detect the presence of new hardware upon boot-up and will
display a dialog window titled NEW HARDWARE FOUND and PCI SCSI BUS CONTROL-
LERS will be highlighted.
• Select: DRIVER FROM DISK PROVIDED BY HARDWARE MANUFACTURER, then
“OK”
• Select SCSI CONTROLLER from the list of available devices, then select “HAVE
DISK...”
2 In the INSTALL FROM DISK window that is displayed, enter the Initio Driver path
name:
Insert INI-9XXXU/9XXXUW DRIVER DISK 1 into drive A:
Type: A:\WIN95, select “OK”
3 Select Initio INI-9XXXU/UW PCI SCSI Host Adapter, select “OK”, then “OK”
again to install the INI910U.MPD driver onto your hard disk drive. It may be necessary to
direct Windows to look for the driver in A:\win95 before the driver can be copied. This step may
need to be repeated more than once.
4 This completes loading the Host Adapter Driver. You must now reboot your system to
activate the SCSI device driver. .
5 It is highly recommended that you verify Initio’s Windows 95 device driver by selecting
MY COMPUTER from the desktop. Then select CONTROL PANEL:
• Select SYSTEM from within the CONTROL PANEL group,
• Select DEVICE MANAGER from within the SYSTEM group,
• Select SCSI CONTROLLER from within the DEVICE MANAGER listing, and
• Select the Initio INI-9XXXU/UW PCI SCSI Host Adapter from within the SCSI
CONTROLLER listing. If “This device is working properly” is displayed on your
screen, the driver has been correctly installed.
Microsoft Windows 95/95b (OSR2) Driver Installation