Initio INI-9090U - Manual (Page 52)

48
initio
®
2 When prompted to INSTALL HOST BUS ADAPTER DRIVERS, insert the INI-9XXXU/
9XXXUW DRIVER DISK 2 into drive A: press <Enter>.
3 When prompted to INSTALL ANOTHER HBA DISKETTE, press <ENTER> to con-
tinue.
4 Follow the directions on screen until you come to a window titled: Loading Initio INI-
9XXX Host Adapter.
• Select CONTINUE INSTALLATION.
• Select CONTINUE INSTALLATION again.
5 This completes loading the host adapter driver. Follow the on-screen directions to
complete the SCO UnixWare installation. For further information regarding UnixWare
installation, refer to the SCO UnixWare Installation Handbook.
Adding the Initio driver to an existing UnixWare system
1 Once a UnixWare session is established and a command prompt is ready, type (recall
that UnixWare is case sensitive):
• cp /stand/unix /stand/unix.org , press <ENTER>
• pkgadd -d diskette1 , press <ENTER>
2 Select i910u ihv hba from the list of available host drivers, press <ENTER>.
3 If the INI-9XXX is intended to be the bootable host adapter, the next step to updating the
driver will require a revision to the I910u file. These instructions will guide you through
changing the current software settings for UnixWare to establish the INI-9XXX as the host
adapter for your boot device:
• At the system command prompt, type
• cd /etc/conf/sdevice.d
• Use “vi” or another editor to modify the file I910u by adding a line
• locate the line $version2
• edit the file by adding the line $static immediately following $version2.
• Rebuild the UnixWare kernel by completing the following steps at the command
prompt :
• /etc/conf/bin/idbuild -B <ENTER>
• cp /etc/conf/cf.d/unix /stand/unix <ENTER>
• cd / <ENTER>
• shutdown -g0 ( 0 is Zero ) <ENTER>
• Y <ENTER>
SCO UnixWare Driver Installation