Initio INI-9090U - Manual (Page 43)

39
initio
®
Overview
The INI-9090U OS/2 driver will support OS/2, 3.0 & 4.0. The device driver for OS/2 is copied
from the INI-9XXXU/9XXXUW DRIVER DISK 1 to your hard drive where it is initialized during
boot-up.
The installation of Initio device drivers to support OS/2 include the following software files
and may be found on the INI-9XXXU/9XXXUW DRIVER DISK 1 :
\OS2\INI910U. ADD INI-9XXX SCSI Host Adapter OS/2 driver.
\OS2\INI910U.DDP Script file for installing INI910U.ADD
Installation
The INI-9XXX driver developed for OS/2 will be installed on the disk drive used for
system initialization. The driver is loaded during the system boot routine and will
remain resident on the drive. Installation of the drivers can be accomplished by
following one of the procedures listed:
• New OS/2 Installation
• Adding INI-9XXX host adapter to existing OS/2
The steps used to install the Initio drivers have different system requirements that may
affect basic operation if not installed properly. It is strongly suggested that the
selected procedure be read and understood before proceeding. Please read all
instructions carefully.
New OS/2 installation:
These instructions will guide you through the Initio OS/2 device driver and OS/2
installation at the same time. The program can be installed from floppy diskettes or
from CD-ROM. The OS/2 driver for the INI-9XXX will be found on the INI-9XXXU/
9XXXUW DRIVER DISK 1 . It is important that the INI-9XXX hardware has been installed
successfully before proceeding further.
1 Make a duplicate copy of OS/2 Diskette 1 using a blank diskette and label it as “OS/2
Diskette 1 for INI-9XXX”.
2 Copy the INI910U.ADD file from the INI-9XXXU/9XXXUW DRIVER DISK 1 (OS/2
subdirectory) to the root directory on the “OS/2 diskette 1 for INI-9XXX”.
IBM OS/2 Driver Installation
9