IBM VERSION 5 SY44-5902-05 - Manual (Page 150)

3. Press the Increment (
↑) or Decrement (↓) buttons until the value of yy appears
next to the function number.
4. Press Enter on the control panel.
5. Press the Increment ( ↑) or Decrement (↓) buttons until ** appears next to the
function number (60**).
6. Press Enter on the control panel.
Setting the zz Position
1. Press the Increment (
↑) or Decrement (↓) buttons until 61 appears in the
Function display.
2. Press Enter on the control panel; ** appears next to the function number.
3. Press the Increment ( ↑) or Decrement (↓) buttons until the value of zz appears
next to the function number.
4. Press Enter on the control panel. Record the data from the display as the base
address.
5. Press the Increment ( ↑) or Decrement (↓) buttons until ** appears next to the
function number (61**).
6. Press Enter on the control panel.
You just entered your address into the system. Now use the “Displaying data from
function 62” procedure to obtain the information from function 62.
Displaying data from function 62
To obtain information from function 62, do the following steps:
1.
Press the Increment (
↑) button until 62 appears in the Function display. Press
Enter on the control panel.
2. Press the Increment (
↑) button until 6200 appears. Press Enter on the control
panel and record the data.
3. Press the Increment (
↑) button until 01 appears after the function number
(6201). Press Enter on the control panel and record the data.
4. Continue until you have the needed data.
5. When you are done, press the Increment ( ↑) or Decrement (↓) buttons until 62**
appears. Press Enter on the control panel.
6. Starting with “Changing the address” on page 134, repeat this procedure until
you have recorded all the needed data as defined by the procedure that sent
you here.
Call your next level of support and give them the information you collected to
write a LIC APAR.
Logical partitions
Logical partitions are the distribution of resources within a single iSeries to make it
operate as if it were two or more independent systems.
Attention: The userid/password used to sign on to SST or DST to perform
logical partition operations requires ’System partitions - operations’ or ’System
partitions - administration’ service tools user privileges. Check with the customer
on the proper userid/password to use when performing logical partition
procedures.
136 Service Functions V5R2