IBM VERSION 5 SY44-5902-05 User Manual
Page 320
Press the F17 key to print a worksheet. If a printer is not available, continue
the procedure by noting the information from the displays onto a piece of
paper.
Note:
Do not use the printout from the Display Description Label Locations
display.
10.
Use the Change Description Label Locations display or worksheet to verify that
all of the system cables and devices are labelled correctly.
11.
Compare the label that is attached to the cable or device with the name that
appears in the Label column.
v Label information matches if the following occurs:
a.
The name on the label that is attached to the cable or device is the same
as the information in the Label column on the display.
Note:
If you replace the previously labeled cable or device during the
system upgrade, be sure to transfer the existing label information
to the replacement cable or device.
v Label information does not match if the following occurs:
a.
There is information in the Label column, but no label is attached to the
cable. (The following steps of this procedure instruct you to create a
label.)
b.
The label that is attached to the cable does not match the information in
the Label column. (The following steps of this procedure instruct you to
change the system label.)
c.
*NONE appears in the Label column, and a label is attached to the cable.
(The following steps of this procedure instruct you to change the system
label.)
d.
*INCORRECT appears in the Label column.
This indicates that the label that is attached to the cable does not match
the information in the Label column. (The following steps of this
procedure instruct you to change the system label.)
12.
Does all of the label information match?
Change Description Label Locations
System: xxx
System type-model/serial . . . . . . . :
940x-xxx / xx-xxxxxxx
Select locations where the label on the actual machine or Label Location
worksheet does not match the label listed below, press Enter.
2=Change
----------------Location-----------------
Frame
EIA
Device
Card
Opt
ID
Location Position Position Port Label
T1
2
CTL01
T1
3
CTL03
T1
4
*INCORRECT
T1
5
*NONE
T1
4
*NONE
T1
5
DKT01
T2
2
*NONE
T2
3
*NONE
T2
4A
QESLINE, QTILINE, ...
More...
F3=Exit
F11=Displaytypes/serial numbers
F12=Cancel
F17=Print
306
Service Functions V5R2