IBM VERSION 5 SY44-5902-05 - Manual (Page 75)

Device Concurrent Maintenance
Type the choices, then press Enter.
Specifyeither Physical Location or Resource Name.
>>> Physical Location . . . Frame ID: 1... Position: L01.. <<<
OR
Resource Name . . . . . Device Resource Name: ..........
Specifyaction as 1=Remove device 2=Install device
Action to be performed . . . . . . . . . : 1
Enter a time value between 00 and 19.
Time delayneeded in minutes . . . . . . : 00
Serial number of frame (not needed if xxxxxxxxxx shown).
Frame serial number . . . . . . . . . : xxxxxxxxxx
F3=Exit F5=Refresh F12=Cancel
For information on how to perform concurrent maintenance for internal tape or
internal optical units, see “Removable Media (Concurrent)” in the Problem
Analysis book for your server.
For information on how to perform concurrent maintenance for internal disk units
with storage protection, see “Disk Unit (Concurrent)” in the Problem Analysis book
for your server.
On some iSeries models informational SRCs occur during concurrent maintenance.
These SRCs indicate when it is safe to perform an action or show the status of the
action. See “SPCN informational concurrent maintenance SRCs” on page 201 to see
the informational SPCN SRCs. For more information about specific SRCs, go to
“(1xxx) System Power Control Network (SPCN) Reference Codes” in the Problem
Analysis information for your server.
See “Concurrent maintenance” on page 63 for general information about IOA or
IOP concurrent maintenance. For removal and installation procedures, see the
applicable card removal and installation procedure in the Problem Analysis
information for your server.
Collecting information and performing functions from the Hardware
Service Manager displays
You can select Packaging hardware resources and Logical hardware resources options
from the Hardware Service Manager display (see “Packaging hardware resources”
on page 47 and “Logical hardware resources” on page 49). This section describes
how to collect information and perform specific functions by using the options and
function keys from the various packaging and logical hardware resources displays.
Change resource details
From packaging displays:
Chapter 2. Hardware Service Manager 61