IBM VERSION 5 SY44-5902-05 - Manual (Page 279)

Table 84. Ethernet/IEEE 802.3 transceiver adapter cable and card wrap (continued)
Interface line name
Adapter connector pin
number Wrap connector pin to
pin (normal wrap) Wrap connector pin to
pin (collision wrap)
Data out - circuit shield (DO-S) 11
Data in - circuit A (DI-A) 5 5 to 3
Data in - circuit B (DI-B) 12 12 to 10
Data in - circuit shield (DI-S) 4
Control in - circuit A (CI-A) 2 2 to 3
Control in - circuit B (CI-B) 9 9 to 10
Control in - circuit shield (CI-S) 1
Voltage common (VC) 6 6 to 13
Voltage plus (VP) 13 13 to 6
Voltage shield (VS) 14
Protective ground (PG) (Conductive
shell) Shell
Facsimile adapter cable wrap connector wiring
Table 85. Facsimile adapter cable wrap connector wiring
Signal designation Wrap connector port A pin to port B pin
OH/DP to RI 11 to 13
AN1 to AN2 9 to 9
AN2 to AN2 10 to 10
RI to OH/DP 13 to 11
+5V to wrap cable logic 19
DL to country or region code 23 to 14
CLK to CLK Wrap 16 to 18
Country or region code to DL 14 to 23
CLK wrap to CLK 18 to 16
Logic ground to wrap cable logic 7
DDI transceiver adapter cable and card wrap
Table 86. DDI transceiver adapter cable and card wrap
Interface line name
Adapter connector pin
number
ICS data connector
Wrap connector pin to
pin
Transmit positive (TX+) 5 Red dot 5 to 1
Transmit negative (TX-) 9 Green dot 9 to 6
Receive positive (RX+) 1 Black dot 1 to 5
Receive negative (RX-) 6 Orange dot 6 to 9
Chapter 9. System Architecture and Configuration 265