IBM VERSION 5 SY44-5902-05 - Manual (Page 65)

The system responds by displaying one of the following messages:
v Resource is not found.
The system displays the following message:
x does not exist as a current resource
name.
(Where x is the resource name that the user specified.)
v Resource is found but is a reserved resource name.
A reserved resource name is created when an OS/400 command (CRTDEVx)
supplies an unassigned resource name. The following message displays:
x exists as a reserved resource name.
Resource does not exist.
(Where x is the resource name that the user specified.)
v Resource is found. If the resource name represents a logical hardware resource,
the Logical Hardware Resources display appears. It allows you to work with the
logical hardware resource. The resource name in the following example is
CC02.
Locate Resource ByResource Name
Type resource name to be located, press Enter.
Resource name . . . . . . . . . .
F3=Exit F9=Unmapped Resource Names F12=Cancel
Figure 9. Example Locate Resource By Resource Name display
Chapter 2. Hardware Service Manager 51