Siemens Brodersen MC55 AT - Manual (Page 140)

MC55_ATC_V04.00 Page 140 of 475 3/17/06
Confidential / Released
7.13 ATS7 Set number of seconds to wait for connection completion
ATS7
specifies the number of seconds the TA will wait for the completion of the call setup when answering or
originating a data call. Also referred to as "no answer timeout". To put it plainly, this is the time to wait for the
carrier signal. If no carrier signal is received within the specified time, the TA hangs up.
Syntax
Parameter Description
Number of seconds to wait for connection completion
000...060
(&F)
Notes
• Command
ATS7
is only applicable to data calls.
• Values greater than 60 cause no error, but
<n>
will be restored to the maximum value of 60.
• The correlation between
ATS7
and
ATS0
is important. If the called party has specified a high value for
ATS0
=
<n>
call setup may fail.
Example: Call setup may fail if ATS7=30 and ATS0=20.
Read Command
ATS7?
Response(s)
<n>
OK
Write Command
ATS7= <n>
Response(s)
OK
ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
V.250 ! % ! % ! ! ! ! !
<n>
(num)(&W)(&V)