Siemens Brodersen MC55 AT - Manual (Page 180)

MC55_ATC_V04.00 Page 180 of 475 3/17/06
Confidential / Released
8.9 AT^MONP Monitor neighbour cells
The
AT^MONP
supplies information of up to six neighbour cells. There are two ways to retrieve the information:
once on request by using the execute command or automatically every
<period>
seconds by using the write
command. To stop the periodic presentation type "AT" or "at".
Syntax
Parameter Description
Display period in seconds
1...254
Notes
• Due to the fact that not all necessary information of the neighbour cells can be decoded during a connection,
there are several constraints to be considered:
- Only neighbour cells that have already been visible in IDLE mode will be further updated, as long as they
are still included in the list.
- Though new neighbour cells can be added to the list (e.g. due to handover), their C1 and C2 parameters
cannot be displayed until the connection is released. In this case "-" is presented for C1 and C2.
- To some extent, the cell monitoring command
AT^SMONC
covers the same parameters. The receiving
level, for example, can be queried with both commands. Yet the resulting values may be slightly different,
even though obtained over a time period of a few seconds. This is quite normal and nothing to worry about,
as the cell information is permanently updated.
• For compatibility with earlier products and to support legacy applications, any input character may be used to
stop the output in certain cases (depending on the settings of
AT+IPR
and
AT+CMUX
).
Test Command
AT^MONP=?
Response(s)
^MONP:
(list of supported
<period>
s)
OK
Exec Command
AT^MONP
Response(s)
See: Section 8.9.1 , AT^MONP responses
OK
Write Command
AT^MONP= <period>
Response(s)
See: Section 8.9.1 , AT^MONP responses
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
SIEMENS ! % % % % % ! ! !
<period>
(num)