Udri, Urat – Siemens Brodersen MC55 AT User Manual
Page 57
MC55_ATC_V04.00
Page 57 of 475
3/17/06
Confidential / Released
"local"
(P)
URC will be indicated by an activated RING line of the interface on which the
URC appears
"asc0"
URC is indicated by an activated RING0 line.
URC Datamode RING line
This parameter specifies whether RING or BREAK is used for the signaling of URCs when the TA-TE link is
reserved (e.g. during circuit-switched data calls, fax connections, in GPRS data mode or during the execution
of an AT command).
Parameter is global for all interfaces, volatile and will not be reset by
"off"
(P)
URC will be indicated by BREAK
"on"
URC is indicated by an active RING line for a time which is configured by the
parameter "URC/Ringline/ActiveTime" (
). The RING line which will be
used, can be configured by the parameter "URC/Ringline" (
).
URC RING line Active Time
This parameter can be used to control how long the RING line is activated to indicate URCs (both for idle inter-
faces and, if configured by the parameter "URC/Datamode/Ringline" (
), if link is reserved) and, if con-
figured by the parameter "GPRS/RingOnIncomingData", to indicate incoming GPRS IP data packets
Parameter is global for all interfaces, volatile and will not be reset by
"0"
RING line will be activated for a time between 4.6 and 9.2 ms.
"1"
RING line will be activated for about 100ms.
"2"
(P)
RING line will be activated for about 1s.
Note
• Parameters "GPRS/ATS0/withAttach" (
) and "GPRS/RingOnIncomingData" (
) are avail-
able only for modules supporting GPRS.
Examples
EXAMPLE 1
Usage of "Audio/AMR":
<udri>
(str)(+CSCS)
<urat>
(str)(+CSCS)
AT+CSCS="UCS2"
Switch to UCS2 character set.
OK
AT^SCFG?
Query all parameters.
...
^SCFG:"Audio/AMR","0065006E00610062006C00650064"
...
OK
AT+CSCS="GSM"
OK
AT^SCFG?
...
^SCFG:"Audio/AMR","enabled"
AMR will be used for any operator.
...
OK
AT^SCFG="Audio/AMR","disabled"
^SCFG:"Audio/AMR","disabled"
AMR is disabled for any operator.
OK
AT^SCFG="Audio/AMR","23405"