Siemens Brodersen MC55 AT - Manual (Page 379)

MC55_ATC_V04.00 Page 379 of 475 3/17/06
Confidential / Released
15.3 AT^SSTGI SAT Get Information
Regularly this command is used upon receipt of an URC "
^SSTN
" to request the parameters of the Proactive
Command.
Then the TA is expected to acknowledge the
AT^SSTGI
response with
AT^SSTR
to confirm that the Proactive
Command has been executed.
AT^SSTR
will also provide any user information, e.g. a selected menu item.
The Proactive Command type value specifies to which "
^SSTN
" the command is related.
Syntax
Parameter Description
MC55 Remote-SAT interface states
0
RESET
1 OFF
2 IDLE
3 PAC
4 WAIT
Related Proactive Command
Test Command
AT^SSTGI=?
Response(s)
^SSTGI:
(list of supported
<state>
s), (list of supported
<cmdType>
s)
OK
Read Command
AT^SSTGI?
Response(s)
^SSTGI: <state>
,
<cmdType>
OK
Write Command
AT^SSTGI= <cmdType>
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
SIEMENS ! % % % % % ! ! !
<state>
(num)
<cmdType>
(num)