Siemens Brodersen MC55 AT - Manual (Page 66)

MC55_ATC_V04.00 Page 66 of 475 3/17/06
Confidential / Released
Unsolicited Result Codes
URC 1
Format of the standard indicator:
+CIEV: <indDescr> , <indValue>
Value related to an indicator has changed.
URC 2
Format of the Voice Message indicator, if the number of waiting messages is delivered by the network:
+CIEV: <indDescr> , <indValue> , <vmCounter>
If the number of waiting messages is not delivered the standard indicator applies.
URC 3
Format of the "eons" indicator:
+CIEV: <indDescr> , <indValue> , <eonsOperator> , <servProvider>
One URC is issued for each new LAI (Location Area Information) broadcast by the network.
URC 4
Format of the "nitz" indicator:
+CIEV: <indDescr> , <nitzUT> , <nitzTZ> , <nitzDST>
Parameter Description
String values and their
<indValue>
ranges.
All indicators supported by
AT+CIND
are accessible with this command, too. A detailed description of these indi-
cators can be found there.
The following indicators are accessible via
AT^SIND
only:
"audio" Activity of the built-in audio unit.
"vmwait1" Voice Message Waiting Indication for line 1
"vmwait1" and "vmwait2" indicate the receipt of a special short message with
a Voice Message Waiting Indicator. The service must be provisioned by the
operator.
The numbers 1 or 2 in "vmwait1" and "vmwait2" are related to the two lines of
the Alternate Line Service (ALS), also defined in CPHS Phase 2 standard. For
further details refer to the
AT^SALS
command.
The presentation mode of the indicator varies with the operator: If more than
one message are waiting, some operators only indicate the first one, others
deliver the indicator each time a new voice message is put into the mailbox.
After the subscriber has retrieved all voice messages the service center auto-
matically sends another message indication which provides the value 0.
Some operators may also send the number of waiting voice messages along
with the indication. In this case, the number will be displayed by the MC55 as
part of the URC. For example, "+CIEV: vmwait1,1,5" notifies that five new voice
messages are waiting. However, it should be noted that neither the read com-
mand
AT^SIND
? nor the write command
AT^SIND
=
<mode>
,2 display the
number of waiting messages.
<indDescr>
(str)
0 Audio unit not active.
1 Value 1 means for example:
Outgoing voice call: Indicator appears when dialing starts.
Incoming voice call: Indicator appears prior to the RING result code.
0 The value 0 notifies that no new voice message is available, and is pro-
vided by the service center to clear the voice message indication after
the subscriber has retrieved all voice messages.
1 The value 1 notifies the subscriber that the mailbox contains one or
several messages.