Siemens Brodersen MC55 AT - Manual (Page 393)

MC55_ATC_V04.00 Page 393 of 475 3/17/06
Confidential / Released
Is a display of the "real"
<location>
of the entry required?
[0] Do not show an entry's "real" location number. Parameter
<location>
will not
be displayed.
1 Show the "real" location number as parameter
<location>
at the end of each
entry.
String type phone number in format specified by
<type>
.
The number parameter may be an empty string.
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
Please consider that for types other than 129 or 145 dialing from phonebook with
ATD><mem><n>
is, depending
on the network, not always possible (refer to GSM 04.08 subclause 10.5.4.7 for details). See also
<type>
of
AT+CPBW
.
Possible values are:
145
Dialing string
<number>
includes international access code character '+'
161 National number. Network support of this type is optional.
209 Dialing string
<number>
has been saved as ASCII string and includes non-
digit characters other than "*", "#" or "+". Note that phonebook entries saved
with this type cannot be dialed.
255 Dialing string
<number>
is a command to control a Supplementary Service,
i.e. "*", "#" codes are contained. Network support of this type is optional.
129 Otherwise
Text assigned to the phone number. The maximum length for this parameter is given in test command response
<tlength>
.
Value indicating the number of used locations in selected memory storage.
The location within phonebook memory at which the corresponding entry is located.
This location may be used for other commands (e.g.
AT+CPBR
or
ATD><mem><n>
)
Maximum length of phone number for "normal" locations. Depending on the storage, a limited number of loca-
tions with extended memory is available per phonebook. Please refer to AT command
AT+CPBW
for detail.
Maximum length of
<text>
assigned to the telephone number. The value indicated by the test command is
given in octets. If the
<text>
string is given in GSM characters, each character corresponds to one octet. If the
<text>
string is given in UCS2, the maximum number of characters depends on the coding scheme used for
the alpha field of the SIM according to GSM 11.11, Annex B [21] . In the worst case the number of UCS2 char-
acters is at least one less than half the number of GSM characters.
<RealLocReq>
(num)
<number>
(str)
<type>
(num)
<text>
(str)(+CSCS)
<used>
(num)
<location>
(num)
<nlength>
(num)
<tlength>
(num)